Cross-Strap Chest Harness with O-Ring Hardware

This black faux leather chest harness features a geometric cross-strap configuration with five silver O-rings positioned at the center chest, shoulders, and sides — a layout that frames the torso rather than simply wrapping it. Rows of evenly spaced silver dome studs run the full length of each strap, adding texture without added bulk.

Strap Layout and Hardware

The harness is built from two horizontal chest bands and two diagonal shoulder straps that converge at a central O-ring. Side O-rings and lobster-claw clasps allow the piece to be put on and removed without pulling it over the head.

• Five O-rings total: one central, two at shoulders, two at lower sides
• Silver dome studs spaced approximately 2 cm apart along every strap
• Lobster-claw closures at each side for easy on/off
• Strap width approximately 2 cm for a defined silhouette without bulk

Festival and Club Styling

Worn over a bare chest this harness suits rave, pride, or club nights where the all-black studded look needs no additional accessories. For cooler weather or a more layered approach, pair it over a fitted black long-sleeve or mesh top — the cross pattern stays readable through sheer fabric. The silver hardware picks up stage lighting and flash photography without adding reflective panels.

• Over bare chest: pairs with high-waisted black trousers and chelsea boots for a minimal festival look
• Over mesh top: adds depth to a monochrome outfit without covering the strap geometry
• Layered under an open leather jacket: the central O-ring remains visible as a focal point

Sizing and Fit

The side clasps and adjustable shoulder straps accommodate a chest circumference of approximately 80 cm to 115 cm. The horizontal chest bands sit just above and below the pectoral line on a standard male torso. Buyers with a chest above 115 cm may find the lower band sits higher than intended — this harness is proportioned for slim to athletic builds. It is not designed to be worn tightly enough to restrict breathing; a two-finger gap between strap and skin is the intended fit.

Material and Care

Straps are cut from faux leather (PU) with a smooth matte finish — not patent or glossy — which keeps the stud detail visually prominent. The metal hardware is zinc alloy with a silver-tone finish; prolonged contact with moisture may cause minor tarnishing over time. Wipe straps with a dry cloth after use; do not submerge in water or machine wash. Store flat or hanging to prevent crease marks in the faux leather.

• Faux leather (PU) straps with matte finish
• Zinc alloy O-rings and studs, silver tone
• Wipe-clean only — no machine washing
• Store flat to avoid permanent crease lines